Furnaces & Oil Heat
Furnace Repair in Providence, RI
A furnace that runs but blows cold air, or one that will not start at all, usually has one failed part behind it. We test the ignition, flame sensor, pressure switch, inducer, blower and limit controls in order and replace the actual failed part, not a handful of guesses.
Gas and oil furnaces that will not ignite, blow cold air, short cycle or trip the limit switch. Typical cost in Providence runs $179 to $1,150, and the phone is answered 24/7 at (401) 598-2964.
Signs it is time to call
- Cold air from the vents while the thermostat calls for heat
- The furnace starts, runs a few minutes and shuts off
- A blinking code light on the control board
- Burning dust, rumbling or squealing from the blower
Forced-air heat is more common in Cranston, Warwick, Johnston and the newer parts of every town around Providence, while oil still heats a good share of older homes beyond the gas mains. Either way, January cold snaps expose the small failures, a dirty sensor, a weak inducer or a clogged nozzle, that a fall visit would have caught.
What the work includes
- Read the board's fault history and check the venting and intake
- Test ignitor, flame sensor, gas valve and pressure switch
- Check blower motor, capacitor and filter restriction
- Check temperature rise and carbon monoxide at the flue before leaving
A dirty filter is behind a surprising share of January no-heat calls in Providence. It overheats the furnace until the limit switch trips, so we check it on every visit.
How the visit goes
- We start with the furnace's fault history and a look at the filter, venting and intake.
- Each part in the ignition and safety chain is tested in order until the failure is found.
- We finish with a combustion and carbon monoxide check before we leave.
What furnace repair usually costs
Most furnace repair jobs in Providence and nearby towns fall between $179 and $1,150. Flame sensor cleaning and ignitors are at the low end; inducer motors, blower motors and control boards at the upper end. We give you the exact price after we see the system, and nothing is done until you approve it.
Compare ranges across all 48 services on the price list.
Furnace Repair questions
Why does my furnace keep shutting off after a few minutes?
Short cycling is often a dirty flame sensor, a clogged filter tripping the limit switch, or a blocked vent. Each one is a straightforward repair once it is found.
Is it safe to keep resetting my furnace?
One reset is fine. If it locks out again, the safety controls are reacting to a real problem, so it is time to have it checked rather than resetting it repeatedly.
Do you repair older furnaces?
Yes. We repair furnaces of most ages and brands, and we will tell you honestly when a furnace has reached the point where repair money is better spent on replacement.
Furnace Repair around Providence
We handle furnace repair across the city and nearby Rhode Island and Massachusetts towns. These are a few of the areas where we do it most.
Need furnace repair today?
Call the line any hour. We will walk you through safe checks and get a technician scheduled.